LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Automatic Transmission Diagnosis - ALLISON) >> Removal & Installation >> Park/Neutral Position Switch >> Removal

Park/Neutral Position Switch: Removal

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the external wiring harness from the PNP switch.
  2. Disconnect the shift linkage from the shift lever (2) on the selector shaft (4). See Figure.
  3. Use wrench (1) to prevent the shift lever (2) from rotating. Remove nut (3) from the end of the selector shaft (4). Carefully remove the shift lever (2) from selector shaft (4).
  4. Remove the two bolts (6). Remove the PNP switch (5) by sliding it outward over the selector shaft (4).
scientia non olet · About LEMON Manuals