LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Automatic Transmission Diagnosis - ALLISON) >> Diagnostic Tests >> DTC P1718: Incorrect Neutral Gear Ratio (2001) >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the diagnostic system check? If so, go to next step. If not, see DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
  2. Check the transmission fluid level. See appropriate AUTOMATIC article in TRANSMISSION SERVICING. Is the transmission fluid level correct? If so, go to next step. If not, see appropriate AUTOMATIC article in TRANSMISSION SERVICING.
  3. Install the scan tool. Start the engine. Record the DTC and failure records. Using the scan tool, check the ignition voltage. Is the voltage 9-18 volts? If so, go to next step. If not, see DTC P0562: SYSTEM VOLTAGE LOW  or DTC P0563: SYSTEM VOLTAGE HIGH  .
  4. Using the scan tool, check input speed and engine speed to verify that the speed sensors are functioning correctly. Did you find a problem? If so, see DIAGNOSTIC TROUBLE CODE DEFINITIONS  under SELF-DIAGNOSTIC SYSTEM. If not, go to next step.
  5. Drive the vehicle under normal operating conditions. Using the scan tool, monitor pressure switch "C", "D", and "E" status. Does the scan tool indicate the correct pressure switch status for each gear range? Refer to pressure switch manifold logic. See Figure. If so, go to next step. If not, see DIAGNOSTIC TROUBLE CODE DEFINITIONS  under SELF-DIAGNOSTIC SYSTEM.
    6. CAUTION: When using the scan tool to perform a clutch test in 4th or 5th gear, never exceed 1400 RPM under stall conditions (with brakes held), or transmission damage may occur.
  6. Connect the pressure gauge to the line pressure tap. See HYDRAULIC PRESSURE TESTS  under PERFORMANCE TESTS. Using the scan tool in clutch test mode, select each forward gear range and check line pressure at 600 RPM and 1400 RPM. Is line pressure consistent with the pressure schedule specifications? If so, go to step  9. If not, go to next step.
  7. Is line pressure low in all gear ranges? If so, see SYMPTOM DIAGNOSIS  under TROUBLE SHOOTING. If not, go to next step.
  8. Do one of the following conditions exist? Line pressure low only in Neutral. Significantly lower in Neutral than in other gear ranges. If so, go to step  10.
  9. Remove the oil pan. See appropriate AUTOMATIC article in TRANSMISSION SERVICING. Inspect the pan for contamination. Inspect the control valve body for sticking valves. Did you find and repair a problem? If so, go to step  11. If not, see SYMPTOM DIAGNOSIS  under TROUBLE SHOOTING.
  10. Inspect for pressure loss in the following areas:
    • Shift Solenoid Seals
    • Valve Body Gaskets
    • Valve Body Passages
    • C1 And C5 Piston Seals

    Did you find and repair a problem? If so, go to next step. If not, see SYMPTOM DIAGNOSIS  under TROUBLE SHOOTING.

  11. Perform the following procedure to verify the repair:
    • Clear the DTC.
    • Operate the vehicle in all gear ranges under normal driving conditions.
    • Using the scan tool, monitor the engine speed and input speed. The difference must be less than 250 RPM.

    Did the DTC return? If so, go to step  1. If not, system is okay.

scientia non olet · About LEMON Manuals