LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Controls - Self-Diagnostics - 8.1L) >> Diagnostic Tests >> DTC P0401: EGR System - Insufficient Flow >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Sierra, 2002 GMC Savana Special, 2002 GMC Savana Camper Special, and 2002 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Diagnostic System Check-Engine Controls? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM.
  2. Are there any MAP DTCs set? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, go to next step.
  3. Inspect the exhaust system for modification of original installed parts or leaks. Repair the exhaust system as necessary if you locate a problem. Did you find and correct the condition? If yes, go to step  7. If no, go to next step.
  4. Check the EGR valve gasket and pipes for leaks. If you locate a problem, clean or replace the EGR system components as necessary. See EXHAUST GAS RECIRCULATION SYSTEM CLEANING under appropriate REMOVAL, OVERHAUL & INSTALLATION article. Did you find and correct the condition? If yes, go to step  7. If no, go to next step.
  5. Remove the EGR valve. Visually and physically inspect the following items for a leak or a restriction:
    • The EGR pintle.
    • The EGR valve passages.

    Did you find and correct the condition? If yes, go to step  7. If no, go to next step.

  6. Remove the EGR inlet pipe from the exhaust manifold. Inspect the manifold EGR ports and the EGR inlet pipe for blockage caused by excessive deposits or other damage. Correct the condition as necessary if a problem is found. Did you find and correct the condition? If yes, go to next step. If no, see DIAGNOSTIC AIDS .
  7. Select the DTC option and the Clear DTC option using the scan tool. Idle the engine at the normal operating temperature. Select the Diagnostic Trouble Code (DTC) option and the Specific DTC option, then enter the DTC number using the scan tool. Operate the vehicle within the Conditions for Running this DTC, if applicable. Does the scan tool indicate that this test failed? If yes, go to step  2. If no, go to next step.
  8. Observe the stored information, Capture Info with a scan tool. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
scientia non olet · About LEMON Manuals