LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 806 (Exterior Trim) >> Repair Instructions >> Panel Replacement - Cargo Box Bridge Side Inner (Avalanche/EXT) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cargo Box Bridge Side Inner Panel (Avalanche/EXT)
    GM741566Courtesy of GENERAL MOTORS CORP.
  1. Install the inner side panel to the vehicle.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the retaining screws (1) to the inner side panel.

    Tighten:  Tighten the inner side panel screws to 7 N.m (62 lb in).

  3. Install the panel - cargo box bridge center. Refer to Panel Replacement - Cargo Box Bridge Center (Avalanche)  or Panel Replacement - Cargo Box Bridge Center (Escalade EXT) .
  4. Install the rear compartment cover assembly.
scientia non olet · About LEMON Manuals