LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 806 (Exterior Trim) >> Repair Instructions >> Panel Replacement - Cargo Box Bridge Center (Avalanche) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the high mounted stop lamp to the cargo box bridge center. Refer to HIGH MOUNTED STOP LAMP REPLACEMENT (UTILITIES) or HIGH MOUNTED STOP LAMP REPLACEMENT (ESCALADE) or HIGH MOUNTED STOP LAMP REPLACEMENT (ESCALADE EXT) or HIGH MOUNTED STOP LAMP REPLACEMENT (AVALANCHE) .
    2. Fig 1: Panel Assembly Screws
    GM741564Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector.
  3. Install the panel assembly to the vehicle.
    4. NOTE: Refer to FASTENER NOTICE .
  4. Install the panel assembly screws (1,2).

    Tighten:  Tighten the panel assembly screws (1,2) to 7 N.m (62 lb in).

  5. Inspect the operation.
  6. Install the rear compartment cover assembly.
scientia non olet · About LEMON Manuals