Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rocker panel molding (3) to the vehicle.
- Align the spring clips (4) to the vehicle.
- Press at sections (4) to secure the rocker panel molding to the vehicle.
- Remove the tape backing (2) and press firmly on the rocker panel molding.
- Install the rear door. Refer to DOOR REPLACEMENT - REAR .