Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Body Side Lower Rear Molding (Avalanche)

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: When any molding is removed, all retaining clips must be replaced if the molding is to be reused.

Remove the retaining screw (1).
Grasp the lower part of the molding.
Pull outward in order to release the clips from the body panel.