Removal Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Grasp the lower part of the molding.
- Pull outwards in order to release the retainers from the body panel.
- Remove all adhesive from the fender and the back of the molding using a 3M™ Scotch Brite molding adhesive remover disc, 3M P/N 07501 or equivalent.
- Clean the body panel using Varnish Makers and Painters (VMP) naphtha.
IMPORTANT:
When this molding is removed, all retaining clips need to be replaced with new clips if the molding is to be reused.
IMPORTANT:
Do not scratch or chip the paint.