LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 806 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Door Body Side >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Door Body Side Molding
    GM741425Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When any molding is removed, all retaining clips needs to be replaced with new ones if the molding is to be reused.
  1. Remove all retaining screws.
  2. Grasp the lower part of the molding.
  3. Pull outwards to release the clips from the body panel.
scientia non olet · About LEMON Manuals