Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- If the location of the emblem/nameplate has not been marked apply tape.
- Warm the pickup box surface with a heat gun J 25070 152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
- Remove the backing from the front end of the emblem/nameplate.
- Press the emblem/nameplate to the pickup box panel surface while continuing to remove the backing.
- Hand roll the emblem/nameplate to the pickup box panel to ensure proper adhesion.
- Inspect the emblem/nameplate for bonding.
- Remove the tape from the area around the pickup box emblem.
IMPORTANT:
Do not touch the adhesive backing of the emblem/nameplate.