LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 806 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Door (W/O SS) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Use the tape for protection and alignment marks for alignment of the new emblem.
  1. Apply tape to the area around the door emblem.
  2. Heat the emblem/nameplate, using a heat gun J 25070  152 mm (6.0 in) from the surface.
  3. Apply the heat using a circular motion for about 30 seconds.
    4. NOTE: Refer to EXTERIOR TRIM EMBLEM REMOVAL NOTICE .
  4. Remove the emblem/nameplate from the door surface using a plastic, flat-bladed tool.
    5. Fig 1: Removing Door Emblem/Nameplate (W/O SS)
    GM348525Courtesy of GENERAL MOTORS CORP.
  5. Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M™ scotch brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
  6. Clean the door surface using varnish makers and painters (VMP) naptha.
scientia non olet · About LEMON Manuals