LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 802 (Front Suspension System) >> Repair Instructions >> Lower Ball Joint Replacement (Torsion Bar Suspension) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Use the outer flange of the ball joint in order to press the ball joint into place.

  1. Install the new ball joint using a press.
  2. Place the lower control arm in a bench vice.
  3. Using a punch, install 4 crimps to the ball joint. Use the replaced ball joint as a reference, the 15-series only.
  4. Install the lower control arm. Refer to Lower Control Arm Replacement (2WD)  or Lower Control Arm Replacement (4WD)  .
  5. Install the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  6. Remove the safety stands.
  7. Lower the vehicle.
  8. Verify the wheel alignment. Refer to SPECIFICATIONS .
scientia non olet · About LEMON Manuals