LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Automatic Transmission Servicing) >> Removal & Installation >> Filler Tube (4L80-E) >> Removal

Filler Tube (4L80-E): Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine air cleaner. Remove the transmission fluid level indicator from the fluid fill tube. Remove the engine cover. On 6.5L models, remove the bolt and the nut securing the transmission fluid fill tube to the engine.
  2. On 8.1L models, remove the nut securing the transmission fluid fill tube to the transmission stud. See Figure . On all models, raise and support the vehicle.
  3. Remove any dirt from the transmission where the fluid fill tube enters the transmission case. Remove the transmission fluid fill tube from the transmission. Pull the tube upward from the transmission.
  4. Remove the transmission fill tube seal. Clean the metal parts using solvent. DO NOT allow the solvent to enter the transmission. Air dry the parts.
scientia non olet · About LEMON Manuals