Accumulator Assembly (4L60-E): Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install the 3-4 accumulator pin into the transmission case. Install the 3-4 accumulator piston onto the pin. The piston legs must face the valve body. Install the 3-4 accumulator piston oil seal ring. Install the 3-4 accumulator piston spring. See Fig 5 . Install the alignment pin on the transmission case.
- Install the case gasket and the valve body gasket to the spacer plate. The case gasket is identified by a "C". The valve body gasket is identified by a "V". Use assembly lubricant to retain the gaskets to the spacer plate. Install the spacer plate and the gaskets to the transmission case. See Fig 4 .
- Install the oil pass cover and the oil pass cover bolts. Tighten the bolts to specification. See TORQUE SPECIFICATIONS .
- Install the 1-2 accumulator piston with the piston legs facing toward the case. See Fig 2 . Install the oil seal ring to the accumulator cover.
- Install the 1-2 accumulator spring onto the piston. Install the 1-2 accumulator cover and the cover bolts. Tighten the bolts to specification. See TORQUE SPECIFICATIONS .
- Remove the alignment pin from the transmission case. Install the control valve body. See VALVE BODY & PRESSURE SWITCH (4L60-E) .