LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Automatic Transmission Servicing) >> Removal & Installation >> 2-4 Servo (4L60-E) >> Installation

2-4 Servo (4L60-E): Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new seals on the pistons and the servo cover. Lubricate the seals with clean transmission fluid. Install the 2-4 servo assembly into the 2-4 servo bore. Install the servo cover and O-ring seal.
  2. Install the servo cover depressor. See Fig 1 . Tighten the bolt on the servo cover depressor in order to compress the servo cover. Install the servo cover retaining ring. Remove the servo cover depressor from the oil pan flange.
  3. Install the oil pan bolt. Tighten the oil pan bolt to specification. See TORQUE SPECIFICATIONS  . Lower the vehicle. Fill transmission with appropriate fluid to proper level. See LUBRICATION  .
Fig 1: Installing Servo Cover Compressor To Transmission
G00089864Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Servo Cover Retaining Ring
G00089865Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Servo O-Ring
G00089866Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals