LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Supplemental Inflatable Restraint System Deactivation Procedures) >> General Motors >> Disabling & Activating Air Bag System >> Disabling System (Catera)

Disabling System (Catera)

WARNING: This page does not describe the selected car, but rather 114 other vehicles, including the 2000 Saturn SW2, 2000 Saturn SL2, 2000 Saturn SL1, 2000 Saturn SL, and 2000 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS . Turn front wheels to straight-ahead position. Turn ignition switch to LOCK position and remove key. Wait at least one minute for capacitors in SDM to discharge before working on system.
  2. Remove upper and lower steering column trim covers. Disconnect the driver air bag module wiring harness connector from steering wheel SIR coil connector.
  3. Remove 4 screws and trim cover from passenger air bag module on right side of instrument panel. For passenger air bag, remove CPA clip and disconnect 2-pin Yellow SIR connector. See Fig 1.
    Fig 1: Locating Passenger's Air Bag Yellow 2-Pin Connector (Catera)
    G98I13894Courtesy of GENERAL MOTORS CORP.
  4. Remove the driver's outer seat track trim cover. Disconnect the driver seat belt pretensioner 2-pin connector from vehicle harness. Remove CPA clip from driver side air bag 2-pin Yellow SIR connector, if equipped. Disconnect Yellow SIR connector from vehicle harness. The connector is located under driver's seat. Repeat procedure for right-hand (passenger) seat belt pretensioner and 2-pin Yellow SIR connector, if equipped.
scientia non olet · About LEMON Manuals