LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Supplemental Inflatable Restraint System Deactivation Procedures) >> Ford Motor Co. >> Passenger Air Bag Module >> Removal & Installation (Cougar)

Removal & Installation (Cougar)

WARNING: This page does not describe the selected car, but rather 114 other vehicles, including the 2000 Saturn SW2, 2000 Saturn SL2, 2000 Saturn SL1, 2000 Saturn SL, and 2000 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see SERVICE PRECAUTIONS . The passenger air bag module is mounted in right side of instrument panel, above glove box. Disable air bag system. See DISABLING SYSTEM . Leave negative battery cable disconnected.
  2. Remove 3 Torx screws at base of glove box. Open glove box. Push in on glove box door tabs and remove glove box. Remove 4 Torx screws and remove panel from behind glove box. Pull passenger air duct from heater box and passenger register, and remove. Disconnect passenger air bag module electrical connector. Remove 2 nuts and 2 bolts from passenger air bag module and remove module.
  3. To install, reverse removal procedure. Tighten passenger air bag module fasteners to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ACTIVATING SYSTEM . Check AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK .
scientia non olet · About LEMON Manuals