LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 798 (HVAC Systems - Manual) >> Repair Instructions >> Recirculation Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of HVAC Module
    GM651483Courtesy of GENERAL MOTORS CORP.
  1. Install the recirculation actuator.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the screws to the recirculation actuator.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

  3. Install the air inlet assembly.
  4. Install the air inlet assembly screws.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

  5. Connect the electrical connector to the recirculation actuator.
  6. Install the HVAC module assembly. Refer to HVAC MODULE ASSEMBLY REPLACEMENT in Heating, Ventilation and Air Conditioning.
scientia non olet · About LEMON Manuals