Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Mode & Air Temperature Actuator

Courtesy of GENERAL MOTORS CORP.

Install the mode actuator (3).

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the screws to the mode actuator (3).
Tighten: Tighten the screws to 1.9 N.m (18 lb in).
Install the I/P carrier. Refer to INSTRUMENT PANEL (I/P) CARRIER REPLACEMENT in Instrument Panel, Gages and Console.