Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Actuator Connector

Courtesy of GENERAL MOTORS CORP.

Install the defroster actuator.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the defroster actuator screws.
Tighten: Tighten the screws to 1.9 N.m (17 lb in).
Connect the electrical connector to the defroster actuator.
Install the I/P carrier. Refer to INSTRUMENT PANEL (I/P) CARRIER REPLACEMENT in Instrument Panel, Gages and Console.