Accumulator & 2-1 Manual Servo: Removal

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Remove the oil pan and filter. See DRAINING & REFILLING under LUBRICATION.
Remove the accumulator bolts. See Fig 1 . Remove the manual 2-1 band servo cover bolts.
Remove the lube oil pipe from the front differential carrier internal gear lube hole. See Fig 3 . Remove the accumulator and the manual 2-1 band servo cover as a assembly. Remove the manual 2-1 band servo cover. Remove the manual 2-1 band servo. See Fig 2 .
To disassemble, inspect and service the accumulator and 2-1 manual servo, see appropriate OVERHAUL article in AUTOMATIC TRANSMISSIONS.

Fig 1: Identifying Accumulator & 2-1 Manual Servo Cover Bolts

Courtesy of GENERAL MOTORS CORP.

Fig 2: Removing & Installing 2-1 Manual Band Servo & Seal

Courtesy of GENERAL MOTORS CORP.

Fig 3: Removing & Installing Accumulator & 2-1 Manual Band Servo

Courtesy of GENERAL MOTORS CORP.