B-Pillar Lower Trim Removal/Installation
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Handling the side air bag sensor improperly can accidentally deploy the side air bag module, which may seriously injure you. Read AIR BAG SYSTEM SERVICE WARNINGS before working around the B-pillar areas. See AIR BAG SAFETY PRECAUTIONS .
NOTE:
- The side air bag sensor is located in the B-pillar.
- Remove the front scuff plate. (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
- Remove the rear scuff plate. (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
- Pull the area marked A, then remove one side of the B-pillar lower trim.
- Pull the B-pillar lower trim outward and remove it.
- Install in the reverse order of removal.