Oil Pressure Switch Removal/Installation [L3]
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before replacing the ATF.
- Remove the battery duct and battery cover.
- Disconnect the negative battery cable.
- Remove the under cover.
- Disconnect the cord assembly connector.
- Remove the oil pressure switch.
- Install the oil pressure switch.
- Tightening torque 17.1-22.1 N.m {1.8-2.2 kgf.m, 12.7-16.2 ft.lbf}
- Connect the oil pressure switch connector.
- Install the under cover.
- Connect the negative battery cable.
- Install the battery duct and battery cover.