Oil Pipe, Hose Clamp, Oil Hose Installation Note

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Apply compressed air to the cooler-side opening, and blow any remaining grime and foreign material from the cooler pipes. Compressed air should be applied for no less than 1 min.

Fig 1: Applying Compressed Air To Cooler-Side Opening
Courtesy of MAZDA MOTORS CORP.
Align the marks, and slide the oil hose onto the oil pipe until it is fully seated as shown.

Fig 2: Aligning Mark Over Oil Pipe And Oil Hose
Courtesy of MAZDA MOTORS CORP.
NOTE:
- If reusing the hose, install the new hose clamp exactly on the mark left by the previous hose clamp. Then apply force to the hose clamp in the direction of the arrow in order to fit the clamp in place.
Install the new hose clamp onto the hose.
Verify that the hose clamp does not interfere with any other components.