LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 784 (Automatic Transaxle [Service, Removal & Installation]) >> Mechanical System Test >> Stall Test

Stall Test

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform mechanical system test preparation. (See Mechanical System Test Preparation .)
  2. Start the engine.
  3. Firmly depress the brake pedal with the left foot.
  4. Shift the selector lever to the D range.
    CAUTION:
    • If the accelerator pedal is depressed for more than 5 s while the brake pedal is depressed, the transaxle could be damaged. Therefore, perform Steps 5 and  6 within 5 s.
  5. Gently depress the accelerator pedal with the right foot.
  6. When the engine speed no longer increases, quickly read the engine speed and release the accelerator pedal.
  7. Shift the selector lever to the N position and idle the engine for 1 min or more  to cool the ATF.
  8. Perform a stall test of the M range and R position in the same manner as in Steps  3- 7.
  9. Turn off the engine.
scientia non olet · About LEMON Manuals