LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 781 (Manual Transaxle Clutch) >> Clutch Unit Removal/Installation >> Flywheel Removal Note

Flywheel Removal Note

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Hold the flywheel using the SST. 
  2. Remove the bolts evenly and gradually in a crisscross pattern.
  3. Remove the flywheel.
  4. Inspect for oil leakage from the crankshaft rear oil seal.
    • If there is any malfunction, replace the crankshaft rear oil seal. (See REAR OIL SEAL REPLACEMENT .)
    Fig 1: Removing Flywheel Using Special Service Tools
    G00975006Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals