Flywheel Installation Note
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Install the flywheel to the crankshaft.
- When reusing the bolts, clean threads and hole, then apply locking compound to the threads.NOTE:
- No locking compound is needed when using new bolts.
- Hand-tighten the flywheel lock bolts.
- Install the SST to the flywheel.
- Gradually tighten the flywheel lock bolts in a crisscross pattern.
- Tightening torque 108-116 N.m 11.1-11.8 kgf.m, 79.7-85.5 ft.lbf}