Clutch Pipe And Clutch Reserve Hose Installation Note

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Return the clutch master cylinder clip to the position shown in the figure.
CAUTION:
- Verify that there is no chipping or damage to the seal ring of the clutch pipe connector.
Insert the clutch pipe connector straight.
Pull the clutch pipe to verify that it does not come off, and reinsert it completely.
Insert the reserve hose connector straight until a click is heard.
Pull the reserve hose to verify that it does not come off, and reinsert it completely.

Fig 1: Inserting Clutch Pipe Connector And Reserve Hose Connector
Courtesy of MAZDA MOTORS CORP.