LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 768 (Body Rear End) >> Repair Instructions >> Pressure Relief Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear bumper fascia. Refer to FASCIA REPLACEMENT - REAR BUMPER .
  2. Pull back the rear compartment trim from the right rear corner in order to expose the pressure relief valve.
  3. Disengage the pressure relief valve tabs from the inside of the rear compartment.

    Remove the pressure relief valve (1) from the quarter panel.

    Fig 1: Removing Pressure Relief Valve
    G01780727Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals