LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 768 (Body Rear End) >> Repair Instructions >> Pressure Relief Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the pressure relief valve (1) to the quarter panel.

    Press inward on the pressure relief valve to fully engage the retaining tabs.

  2. Install the rear compartment trim to its original position.
  3. Install the rear bumper fascia. Refer to FASCIA REPLACEMENT - REAR BUMPER .
    Fig 1: Installing Pressure Relief Valve
    G01780728Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals