LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 768 (Body Rear End) >> Repair Instructions >> Lock Striker Replacement - Rear Compartment Lid >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear compartment lid lock striker to the vehicle.
  2. Install the rear compartment lid lock striker nuts (1) to the lock striker.

    Hand tighten the rear compartment lid lock striker nuts.

    3. Fig 1: Locating Rear Compartment Lid Lock Striker Nuts
    G01780726Courtesy of GENERAL MOTORS CORP.
  3. Adjust the rear compartment lid alignment and closing effort as necessary.
    CAUTION: Refer to FASTENER NOTICE .
  4. Tighten the rear compartment lid lock striker nuts.

    Tighten 

    Tighten the nuts to 7 N.m (62 lb in).

  5. Install the rear bumper fascia. Refer to FASCIA REPLACEMENT - REAR BUMPER .
  6. Install the rear compartment sill trim plate. Refer to Compartment Sill Plate Replacement - Rear .
  7. Close the rear compartment.
scientia non olet · About LEMON Manuals