LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 765 (Emission System) >> Evaporative Emission (EVAP) System Leak Detection Pump Removal/Installation >> EVAP System Leak Detection Pump Removal Note

EVAP System Leak Detection Pump Removal Note

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Support the rear crossmember using a transmission jack.
  2. Remove the rear wheels.
  3. Disconnect the ABS wheel-speed sensor wiring harness connector.
  4. Disengage the brake pipe mount from bracket.
    Fig 1: Locating Brake Pipe Mount
    G00973040Courtesy of MAZDA MOTORS CORP.
  5. Remove the rear shock absorber lower bolts. (See REAR SHOCK ABSORBER REMOVAL/INSTALLATION .)
  6. Loosen the rear crossmember installation nuts (6 locations) and lower the rear crossmember approx. 140 mm {5.5 in}  . (See REAR CROSSMEMBER REMOVAL/INSTALLATION .)
  7. Disconnect the breather hose.
  8. Remove the installation bolt and remove the EVAP system leak detection pump.
scientia non olet · About LEMON Manuals