LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 764 (Exhaust System) >> Exhaust System Removal/Installation >> Main Silencer Removal Note >> California emission regulation applicable model

California emission regulation applicable model

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear wheels and tires.
  2. Disconnect the ABS wheel-speed sensor wiring harness connector.
  3. Disengage the brake pipe mount from bracket.
    Fig 1: Locating Brake Pipe Mount - California Emission Regulation Applicable Model
    G00973701Courtesy of MAZDA MOTORS CORP.
  4. Remove the caliper component installation bolts, remove the parking brake cable from the caliper, and then set the caliper out of the way. (See REAR BRAKE ROTOR .)
  5. Remove the rear shock absorber lower bolts. (See REAR SHOCK ABSORBER REMOVAL/INSTALLATION .)
  6. Remove the rear trailing link installation bolts (4 locations). (See REAR TRAILING LINK REMOVAL/INSTALLATION .)
  7. Remove the rear crossmember component installation bolts (6 locations) and lower the rear crossmember component. (See REAR CROSSMEMBER REMOVAL/INSTALLATION .)
  8. Remove the main silencer.
scientia non olet · About LEMON Manuals