LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 763 (Fuel System) >> Fuel Tank Removal/Installation >> Fuel-filler Pipe Removal Note

Fuel-filler Pipe Removal Note

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear tire (RH).
  2. Remove the rear mudguard (RH).
  3. Support the rear crossmember using a transmission jack.
  4. Remove the rear shock absorber (RH) lower bolts. (See REAR SHOCK ABSORBER REMOVAL/INSTALLATION .)
  5. Loosen the rear crossmember installation nuts (6 locations) and lower the rear crossmember 30 mm {1.2 in}.  (See REAR CROSSMEMBER REMOVAL/INSTALLATION .)
  6. Remove the fuel-filler pipe.
scientia non olet · About LEMON Manuals