No.1 Engine Mount Rubber Installation Note

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine jack and attachment.

CAUTION:

Tighten the bolts in the order shown in the figure to prevent abnormal noise and vibration after assembly.

Fig 1: Tightening No.1 Engine Mount Rubber Installation Bolts

Courtesy of MAZDA MOTORS CORP.

Tighten the No.1 engine mount rubber installation bolts as shown in the figure.
Tightening Torque

93.1-116.6 N.m {9.50-11.88 kgf.m, 68.7-85.9 ft.lbf}