LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 759 (Engine Mechanical (Service Information)) >> Drive Belt Replacement >> A/C Drive Belt

A/C Drive Belt

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine under cover and splash shield (RH).
  2. Cut the A/C drive belt using scissors.
    Fig 1: Cutting A/C Drive Belt Using Scissors
    G00973716Courtesy of MAZDA MOTORS CORP.
    3. NOTE:
    • The jig is prepackaged with a new A/C drive belt.
    Fig 2: Installing Jig To Crankshaft Pulley
    G00973717Courtesy of MAZDA MOTORS CORP.
  3. Install a jig (A) to the crankshaft pulley as shown in the figure.
  4. Install a new A/C drive belt to the A/C compressor pulley, move jig (A) upward, and then install the A/C drive belt to the crankshaft pulley.
    Fig 3: Installing A/C Drive Belt To Crankshaft Pulley
    G00973718Courtesy of MAZDA MOTORS CORP.
  5. Install jig (B) to the A/C compressor mount as shown in the figure.
    Fig 4: Installing Jig To A/C Compressor Mount
    G00973719Courtesy of MAZDA MOTORS CORP.
    6. CAUTION:
    • The A/C drive belt cannot be reused.
    NOTE:
    • The jig is prepackaged with a new A/C drive belt.
    • Do not pass jig (B) through the A/C compressor mount hole.
  6. Rotate the crankshaft pulley to the right using a wrench and install the A/C drive belt.
  7. Install the under cover and splash shield (RH).
    Fig 5: Installing A/C Drive Belt By Rotating Crankshaft Pulley
    G00973720Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals