Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate a NEW O-ring seal with transmission fluid.
- Install the VSS and bolt. Tighten the VSS bolt to 10 N.m (89 lb in).
- If equipped with the 8.1L engine, connect the VSS electrical connector (5).
- If equipped with the 6.6L engine, connect the VSS electrical connector (4).
- Lower the vehicle.
- Check the transmission fluid level. Add if necessary.