LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 756 (Manual Transmission - ZF S6-650) >> Repair Instructions >> Transmission Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Important:  The J 44732 will set the oil seal to the proper depth. Failure to use the J 44732 will cause improper installation of the oil seal.

  1. Using J 44732 install the rear oil seal.
  2. Install the yoke.
  3. Use the J 8614-01 in order to hold the yoke.
  4. Install a NEW yoke nut. Tighten the yoke nut to 330 N.m (244 lb ft).
  5. Install the rear propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - ONE PIECE or PROPELLER SHAFT REPLACEMENT - TWO PIECE .
  6. Check the transmission fluid level. Add if necessary.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals