LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 756 (Manual Transmission - ZF S6-650) >> Repair Instructions >> Transmission Input Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle.
  2. Remove the rear propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - ONE PIECE or PROPELLER SHAFT REPLACEMENT - TWO PIECE .
  3. Remove the transmission. Refer to Transmission Replacement .

    Important:  The clutch actuator hose can remain connected to the clutch actuator. Disconnecting the hose from the clutch actuator will allow the hydraulic fluid to drain from the hydraulic system.

  4. Remove the clutch actuator cylinder bolts. Do not disconnect the hose from the actuator.
    5. Fig 1: Clutch Actuator Cylinder
    G01715494Courtesy of GENERAL MOTORS CORP.
  5. Remove the clutch actuator cylinder.
  6. Remove the front oil seal using J 23907 (2) and J 44748 (1).
    Fig 2: Front Oil Seal
    G01715495Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals