LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 756 (Manual Transmission - ZF S6-650) >> Repair Instructions >> Shift Lever Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a NEW shift lever insulator, if required.
  2. Apply gasket maker GM P/N 12378517 or equivalent to the surface of the control lever assembly.
  3. Push the shift lever assembly back through the insulator, position and turn the shift lever assembly back into place.
  4. With a flat tool pull back the insulator between the body and transmission to install the shift lever assembly bolts.
  5. Install the shift lever assembly bolts. Tighten the shift lever assembly bolts to 23 N.m (17 lb ft).
  6. Install the control lever and boot. Refer to Control Lever And/Or Boot Replacement .
scientia non olet · About LEMON Manuals