LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 754 (Manual Transmission - NV 3500) >> Repair Instructions >> Control Lever And/Or Boot Replacement >> Installation Procedure.

Installation Procedure.

WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the control lever insulator, if removed.
  2. Install the control lever boot to the control lever, if removed.
  3. Install the control lever.
  4. If alignment of the control lever is necessary, or if the shift lever assembly was replaced perform the following:
    1. 4.1. The nut must be seated at the bottom of the thread runout on the shift lever.
    2. 4.2. Seat the control lever against the shift lever assembly adjustment nut.
    3. 4.3. Back the control lever off the nut in order to align the index mark on the control lever perpendicular to the edge of the control lever boot retainer.
    4. 4.4. Ensure that the index mark is located on the passenger side and that the shift pattern is aligned parallel to the vehicle centerline or rotated no more than 6 degrees clockwise.
    5. 4.5. Hold the control lever and tighten the shift lever assembly nut against the control lever. Tighten the shift lever assembly nut to 37 N.m (27 lb in).
  5. Seat the control lever boot to the floor.
  6. Install the control lever boot screws, if removed. Tighten the control lever boot screws to 1.6 N.m (14 lb in).
  7. Install the control lever boot retainer, if removed.
  8. Install the control lever boot retainer plastic retainers, if removed.
scientia non olet · About LEMON Manuals