LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 753 (Body Front End) >> Repair Instructions >> Seal Replacement - Hood Rear Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Remove the hood rear side seal (1) from the pinch weld flange.
  3. Using 3M™ P/N 8984 adhesive remover clean off any adhesive left on the pinch weld flange.
    Fig 1: Removing Hood Rear Side Seal
    G01780164Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals