LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 753 (Body Front End) >> Repair Instructions >> Hood Latch Striker Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the hood latch striker (1) to the hood to the marks on the hood.
    CAUTION: Refer to FASTENER NOTICE .
  2. Install the hood latch striker bolts (2) to the hood.

    Tighten 

    Tighten the bolts to 25 N.m (18 lb ft).

  3. Adjust the hood latch striker if necessary.
  4. Close the hood.
    Fig 1: Installing Hood Latch Striker
    G01780147Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals