LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 748 (Engine Mechanical - 3.1L (On-Vehicle)) >> Repair Instructions >> Valve Rocker Arm and Push Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the valve rocker arm covers. Refer to Valve Rocker Arm Cover Replacement - Right (Rear)  and Valve Rocker Arm Cover Replacement - Left (Front)  .

    Important:  Keep the components separated in order to install the components in the same location.

  2. Remove the rocker arm bolts.
  3. Remove the rocker arms.

    Important:  Keep the pushrods in order in order to install the pushrods in the original position.

  4. Remove the pushrods.
    Fig 1: Removing Pushrods
    G01810944Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals