LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 734 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad - Rear Split Folding >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the split/folding rear seat back. Refer to Seat Back Replacement - Rear Split Folding  .
  2. Remove the pivot bolt and bushing from the split/folding rear seat back.
    Fig 1: Removing Split/Folding Rear Seat Back Pivot Bolt
    G01780612Courtesy of GENERAL MOTORS CORP.
  3. Disconnect hook and loop strip retaining the rear seat cushion cover back and pull back to access the staples.
    Fig 2: Accessing Rear Seat Cushion Staples
    G01780613Courtesy of GENERAL MOTORS CORP.
  4. Remove the staples from the seat back cover.
  5. Reach inside of the rear seat back cover in order to unfasten the hook and the loop retainers securing the rear seat back cover to the pad.
    Fig 3: Removing Staples
    G01780614Courtesy of GENERAL MOTORS CORP.
  6. Remove the seat back cover from the seat back pad.
    Fig 4: Removing Seat Back Cover
    G01780615Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals