Installation Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Install the seat back cover to the seat back pad.
Use firm hand pressure in order to fasten the hook and the loop retainers, securing the rear seat back cover to the pad.

Fig 1: Installing Seat Back Cover To Seat Back Pad
Courtesy of GENERAL MOTORS CORP.
Install the seat back cover to the split/folding rear seat back.

Fig 2: Installing Seat Back Cover To Split/Folding Rear Seat Back
Courtesy of GENERAL MOTORS CORP.
Install the new staples to the split/folding rear seat back.

Fig 3: Installing Staples
Courtesy of GENERAL MOTORS CORP.
Use firm hand pressure in order to fasten the hook and the loop retainer on the rear split folding seat back cover.

Fig 4: Fastening Hook & Loop Retainer
Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to FASTENER NOTICE .
Install the pivot bolt and bushing to the split/folding rear seat back.
Tighten

Tighten the pivot bolt to 10 N.m (89 lb in).
Install the split/folding rear seat back. Refer to Seat Back Replacement - Rear Split Folding .

Fig 5: Installing Pivot Bolt & Bushing
Courtesy of GENERAL MOTORS CORP.