Front or Rear Vertical Travel
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Operate the seat control switch until one adjuster reaches the fully raised position at the front and the rear vertical travel limits.
- Disconnect both vertical drive cables (1) from the adjuster that has reached the fully raised position.
- Operate the seat control switch until the other adjuster reaches the fully raised position at the front and the rear vertical travel limits.
- Connect the front and the rear vertical drive cables (1).
- Operate the adjusters through 2 complete cycles in order to inspect the vertical travel.
- Repeat this procedure as necessary if the adjusters do not appear to be in phase after the test cycle.