LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 734 (Seat System) >> Repair Instructions >> Seat Adjuster Handle Replacement - Two-Way Manual >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat adjuster release handle to the seat track studs.
    Fig 1: Installing Seat Adjuster Release Handle
    G01780587Courtesy of GENERAL MOTORS CORP.
  2. Install the release handle retaining clips, pressing into place until fully seated.
  3. Position the front seat to the original position.
    Fig 2: Installing Release Handle Retaining Clips
    G01780588Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals