Installation Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Important: Remove any twists in the seat belt webbing before final assembly.

Install the rear seat outer retractor side belt.
CAUTION: Refer to FASTENER NOTICE .
Install the rear seat belt retractor bolt (1).
Tighten

Tighten the rear seat belt retractor bolt to 36 N.m (27 lb ft).
Install the rear seat belt retractor anchor plate bolt.
Tighten

Tighten the rear seat belt retractor anchor plate bolt to 42 N.m (31 lb ft).
Install the rear window panel trim. Engage the retainers.

Fig 1: Installing Rear Seat Belt Retractor
Courtesy of GENERAL MOTORS CORP.
Install the rear seat cushion. Refer to SEAT CUSHION REPLACEMENT - REAR in Seats.
Install the rear seat back cushion. Refer to SEAT BACK REPLACEMENT - REAR in Seats.