LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 728 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Right Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat belt retractor onto the seat. Line up the tab on the retractor to the tab on the seat frame.
  2. Install the upper anchor bolt. Tighten the bolt to 53 N.m (39 lb ft).
  3. Install the retractor tower cover.
  4. Install the retractor tower cover retaining screw. Tighten the screw to 2 N.m (18 lb in).
  5. Install the retractor.
  6. Install the retractor bolt. Tighten the bolt to 53 N.m (39 lb ft).
  7. Install the rear cardboard panel retainers.
  8. Install the seat back cover and pad. Refer to SEAT BACK COVER & PAD REPLACEMENT - FRONT .
  9. Move the seat to its original position.
scientia non olet · About LEMON Manuals